switchingloop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
switchingloop [2022/04/07 17:48] – [Example of Switch Loop and Fix] jim | switchingloop [2022/06/17 18:41] (current) – [Finding Switch Loops] jim | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | =====Switching | + | =====Switch |
- | Switching loops are caused when ethernet cables get plugged in willy-nilly-wack-a-mole and create a physical and logical loop. That' | + | Switch Loops are caused when ethernet cables get plugged in willy-nilly/whack-a-mole and create a physical and logical loop. That' |
- | The #1 symptom is network connections (like phones, sound systems, etc..) | + | The #1 symptom |
- | ====Example of Switch Loop and Fix==== | + | ====Example of a Switch Loop and Fix==== |
{{ :: | {{ :: | ||
- | In this video, a switch loop is created because the top and bottom switches are connected to the router as well as to each other. Removing either redundant ethernet cable and connection will solve the issue. At the beginning of the video, notice how all the switch lights are on and blinking rapidly. | + | In this video, a switch loop is created because the top and bottom switches are connected to the router as well as to each other. Removing either redundant ethernet cable/connection will solve the issue.\\ |
+ | At the beginning of the video, notice how all the switch lights are on and blinking rapidly. | ||
- | A proper network design can be simple or complex, the trick is that it is hierarchical and not more than one path. Yes, there are exceptions using special equipment and configuration, | + | A proper network design can be simple or complex. The trick is to ensure |
====Finding Switch Loops==== | ====Finding Switch Loops==== | ||
This might be simple, just examining most network cables for cross connects may show you 2 or three cables between switches. In the video above, there is a 3rd switch off camera that both bottom switches are plugged into, as well as a cross connect. | This might be simple, just examining most network cables for cross connects may show you 2 or three cables between switches. In the video above, there is a 3rd switch off camera that both bottom switches are plugged into, as well as a cross connect. | ||
- | **Basic: | + | **Basic:** Try unplugging cables one at a time and waiting for 30-90 seconds before plugging back in to see if the blinky light chaos stops and your internet connections as well as device-to-device connections improve. |
{{ : | {{ : | ||
- | Advanced: It could be so bad that you decide that it's time to clean up and label cables, this is a good time to unplug everything, and plug them in one by one watching for that tell-tale | + | **Advanced:** It could be so bad that you decide that it's time to clean up and label cables. This is a good time to unplug everything, and plug them in again one by one, watching for that tell-tale blinking light chaos. |
- | Sometimes, the problem is created by a remote switch or device (like a switch or router/ | + | **Sometimes**, the problem is created by a remote switch or device (like a switch or router/ |
- | And probably our best advice: **Hire a professional**. If you are having such problems, a little technology tune-up from a professional can be the start of a wonderful mutually beneficial relationship. | + | **And probably our best advice: |
| |
switchingloop.1649353695.txt.gz · Last modified: 2022/04/07 17:48 by jim