Differences

This shows you the differences between two versions of the page.

--- manual-config:snom-paplus [2026/02/26 16:06] – joe
+++ manual-config:snom-paplus [2026/02/26 16:15] (current) – joe
@@ Line 63: / Line 63: @@
 {{:manual-config:snom2.png?650| }}
-If you are configuring your SNOM for use as a ringer, put this new manual extension in the group you want it to ring with and your setup is complete.
+If you are configuring your SNOM for use as a ringer with a PA speaker, put this new manual extension in the group you want it to ring with and your setup is complete.
-If you want to use your PA speaker as a standalone intercom, click on the manual extension again and check the box for **Intercom Mode**. Use the extension given to dial the speaker in intercom mode. If your extension is 150, intercom mode will enable as extension 250.
+If you want to use a PA speaker as a standalone intercom, click on the manual extension again and check the box for **Intercom Mode**. Use the extension given to dial the speaker in intercom mode. If your extension is 150, intercom mode will enable as extension 250.
+{{:manual-config:intercom.png?600|}}
 --------------------------------------------------------------------------------------------------------
@@ Line 71: / Line 73: @@
 ===== Multicast Paging Setup =====
+These settings are only necessary if you intend to use multicast paging.
 ===== STEP 1 =====
@@ Line 78: / Line 81: @@
 {{:manual-config:snommulticast.png?650| }}
+--------------------------------------------------------------------------------------------------------
 Enter a name for the paging group and its multicast address.
@@ Line 85: / Line 90: @@
 {{:manual-config:multicast-address.png?650| }}
+--------------------------------------------------------------------------------------------------------
 Click **Identity 1** again on the left side of the screen, then click the **SIP/RTP** tab. Add the multicast address and port to the **Multicast relay address** box:
 {{:manual-config:broadcast-relay.png?650| }}
 Click apply and the paging group should be ready to use by dialing the extension number. To configure another group, repeat this process with another manual extension and use Identity 2 through 4 to configure it.