=====Getting Started===== This page provides basic setup/installation instructions, including the list of the packaging contents, and also information for obtaining the best performance from your GRP261X series phone. ====Equipment Packaging==== ^ Qty ^ Item ^ | 1 | Phone Main Case | | 1 | Handset | | 1 | Phone Stand | | 1 | Ethernet Cable | | 1 | Power Adapter | | 1 | Phone Cord | | 1 | Quick Installation Guide | | 1 | GPL License | {{:equipment_package_contents.png?nolink&675 |GRP2614, GRP2615, GRP2616 Package Contents}} \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ \\ ====Using the Phone Stand==== To install the phone on the table with the phone stand, attach the phone stand to the bottom of the phone through the phone stand slot. (Upper half, bottom part). ====Using the Slots for Wall Mounting==== - Attach the wall mount spacers to the slot for wall mount spacers on the back of the phone. - Attach the phone to the wall via the wall mount hole. - Pull out the tab from the handset cradle (See figure below). - Rotate the tab and plug it back into the slot with the extension up to hold the handset while the phone is mounted on the wall (See figure below). {{:wall_mount_.png?nolink&675 |Wall Mount Instructions}} \\ ====Connecting the GRP261X==== To setup the GRP261X, follow the steps below: - Connect the handset and main phone case with the phone cord. - Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a router (LAN side of the router) using the Ethernet cable. - Connect the PSU output plug to the power jack on the phone; plug the power adapter into an electrical outlet. If PoE switch is used in step 2, this step could be skipped. - The LCD will display provisioning or firmware upgrade information. Before continuing, please wait for the date/time display to show up. - Using the phone embedded web server or keypad configuration menu, you can further configure the phone using either a static IP or DHCP. {{:connecting_the_grp261x.png?nolink&675 |}}